Tools Required

J 25070 Heat Gun

1. Heat the weld join molding, using J 25070 152 mm (6 in) from the surface.

Apply the heat using a circular motion for about 30 seconds.

2. Remove the weld joint molding, begin at one end using a small plastic flat-bladed tool and peel the weld joint molding away from the weld joint.



3. Remove all adhesive from the body panel using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
4. Clean the body panel using Varnish Makers and Painters (VM&P) naphtha.

1. Warm the body panel with J 25070 to a minimum of 21°C (70°F).
2. Remove 12-15 cm (5-6 in) of the protective liner at the front edge of the weld joint molding.
3. Align and center the front edge of the weld joint molding with the front edge of the weld joint.
4. Use hand pressure in order to press the weld joint molding into place.
5. Continue to peel back the liner, center the molding and press into the weld joint.
6. Hand roll the loose ends.