Circuit Description
The Body Control Module (BCM) uses a key in ignition input in order to control certain features in the vehicle. These features are in the following systems:
| • | Content Theft Deterrent (if equipped) |
| • | Audible Warnings |
| • | Automatic Door Locks |
The ignition switch switches the key in ignition input circuit to ground when you fully insert the ignition key into the ignition switch. This in turn pulls the BCM key in ignition input low.
Conditions for Running the DTC
The ignition is on.
Conditions for Setting the DTC
| • | The ignition 0 input is active (high signal) and the key in ignition input is inactive (high signal). |
| • | The conditions above must be present for more than 0.3 seconds. |
Action Taken When the DTC Sets
The BCM stores DTC B2964 in memory.
Conditions for Clearing the DTC
| • | The DTC becomes history when the fault is no longer present. |
| • | A history DTC will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present. |
| • | You may use a scan tool in order to clear the DTC. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
SCHEMATIC REFERENCE: Audible Warnings Schematics | ||||
1 | Did you perform the Audible Warnings Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the Key In Ignition parameter display Active? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the test lamp illuminate? | -- | Go to Step 7 | Go to Step 4 |
4 | Test the key in ignition input circuit for an open or a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 5 |
5 | Test the ground circuit of the ignition key alarm switch for an open or a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 6 |
6 | Inspect for poor connections at the harness connector of the ignition switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
8 | Replace the ignition switch. Refer to Ignition and Start Switch Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 |
Important: Perform the set up procedure for the replacement BCM. Replace the BCM. Refer to Body Control Module Replacement in Body Control Systems. Did you complete the replacement? | -- | Go to Step 10 | -- |
10 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
