Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Move the window to the full up position and secure in place with tape.
2. Remove the interior trim panel. Refer to Rear Side Door Trim Panel Replacement .
3. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
4. Loosen the bolts on the clamps that secure the window to the regulator.

1

Side Door Window Regulator Bolt (Qty: 2)

Tighten
10 N·m (89 lb in)

2

Side Door Window Regulator Bolt

Tip
Loosen the bolt enough so that the regulator assembly will lift out of the t-slot in the door inner panel.

Tighten
10 N·m (89 lb in)

3

Rear Side Door Window Regulator Assembly

Tip
Disconnect the electrical connector.