- Remove the sound insulator. Refer to
Instrument Panel Insulator Replacement
.
- Ensure that the cruise control release switch retainer is fully seated in the bracket.
- Remove the cruise release switch from the switch retainer. Rotate the switch counter clockwise to release the switch.
- Pull back lightly on the brake pedal to ensure the system is fully released.
- While lightly holding the pedal, install and adjust the cruise release switch:
| 5.1. | Insert the cruise release switch into the retainer. |
| 5.2. | Ensure the switch plunger is fully depressed against the switch contact rubber bumper without deflecting the bracket or the switch contact arm on the pedal. |
| 5.3. | Rotate the switch clockwise to secure the switch in the retainer. |
- Release the brake pedal and inspect the switch barrel to switch contact rubber clearance (1).
Specification
Clearance should not exceed 1.2 mm (0.047 ).
- Ensure that the following contacts open at 25.4 mm (1 in) or less of pedal travel:
| • | The cruise release switch. |
| • | The stop lamp and torque converter clutch (TCC) switch. |
- Ensure the switches open simultaneously or before the onset of braking.
- The brake pedal may travel up to 25.4 mm (1 in) before the cruise control system disengages.
- Install the sound insulator. Refer to
Instrument Panel Insulator Replacement
.
