GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 HHR 🢒 Accessories 🢒 Cellular Communication 🢒 Inside Rearview Mirror Replacement

Removal Procedure

    Object Number: 311618 Size: SH
  1. Disconnect the electrical connector (3) from the back of the mirror.
  2. Remove the wire harness cover.
  3. Adjust the mirror to the full upward position.

    4. Object Number: 330783 Size: SH
  4. Loosen the screw at the base in order to remove the mirror from the button.
  5. Slide the mirror in an upward motion in order to remove.

Installation Procedure

    Object Number: 330783 Size: SH
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button.
  2. Slide the base of the mirror onto the button.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.

    4. Tighten
    Tighten the screw (3) to 1.8 N·m (16 lb in) in order to secure the mirror base to the button.


    Object Number: 311618 Size: SH
  4. Connect the electrical connector (3) to the back of the mirror.
  5. Install the wire harness cover.
  6. Reposition the mirror.
  7. Refer to Control Module References for programming and setup information.