Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

1. Turn the ignition switch to the OFF position.
2. Remove the cover from the engine control module (ECM) and transmission control module (TCM).
3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
4. Disconnect the electrical connector from the EBCM.

1

Bolts, Electronic Brake Control Module (EBCM)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2.3 N·m (20 lb in)

2

Seal, EBCM O-Ring (Qty: 8)

Tip

3

EBCM

Tip