The Keyless Entry Scan Tool Data List contains all of the keyless entry related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The column, Data List, indicates the location of the parameter within the scan tool menu selections. Use the Keyless Entry Scan Tool Data List as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with the Diagnostic System Check - Vehicle in Vehicle DTC Information. Use the Scan Tool Data List only after the following is determined:
| • | There is no published DTC procedure nor published symptom procedure for the customer concern. |
| • | The DTC or symptom diagnostic procedure indicated by the diagnostic system check does not resolve the customer concern. |
The Typical Data Values are obtained from a properly operating vehicle under the conditions specified in the first row of the Scan Tool Data List table. Comparison of the parameter values from the suspect vehicle with the Typical Data Values may reveal the source of the customer concern.
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Ignition in RUN, Engine OFF | |||
Last 4-Digit of GM Part Number | Controller Information | 4-digit number | 7669 |
Calibration ID | Controller Information | 4-digit number | 0001 |
Invalid Transmitter | Key Fob Information | Greater than or less than 10 counts | Less than 10 counts |
Key Pressed on FOB | Key Fob Information | Trunk/Lock/Unlock/Panic | Unlock |
Last Fob Used | Key Fob Information | Fob # | Fob #1 |
No. of Fob's Programmed | Key Fob Information | 1-4 | 2 |
PROM ID | Module Information | 4-digit number | 9060 |
