For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC P0601: Control Module Read Only Memory (ROM)DTC P0602: Control Module Not Programmed
DTC P0603: Control Module (TCM) Long Term Memory Reset
DTC P0604: Control Module Random Access Memory (RAM)
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the transmission control module (TCM) system. This diagnostic also addresses if the TCM is not programmed.
Conditions for Running the DTC
| • | The ignition is ON, or the engine is operating. |
| • | The DTCs run once an ignition cycle. |
Conditions for Setting the DTC
P0601
The TCM detects that the checksum calculation does not match the expected checksum.
P0602
The TCM is identified as not programmed.
P0603
The TCM detects an incorrect copy of non-volatile memory.
P0604
The TCM detects a random access memory (RAM) read/write error.
Action Taken When the DTC Sets
P0601 and P0602
| • | DTCs P0601, and P0602 are Type A DTCs. |
| • | The transmission will operate in 5th gear in D or M range, 2nd gear in L range. |
P0603
| • | DTC P0603 is a Type C DTC. |
| • | The TCM uses default EEPROM values. |
| • | The TCM disables engine start. |
P0604
DTC P0604 is a Type A DTC.
Conditions for Clearing the DTC
| • | DTCs P0601, P0602, and P0604 are Type A DTCs. |
| • | DTC P0603 is a Type C DTC. |
Reference Information
Description and Operation
Electronic Component Description
DTC Type Reference
Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Verification
- Ignition ON, observe the DTC information with a scan tool. Verify that DTC P0602 does not fail this ignition cycle.
- Observe the DTC information with a scan tool. Verify that DTCs P0601, P0603, and P0604 do not set this ignition cycle.
| ⇒ | If DTC P0602 failed this ignition, reprogram the TCM. Refer to Control Module References . If DTC P0602 resets, replace the TCM. |
| ⇒ | If any of the DTCs P0601, P0603, or P0604 are set this ignition cycle replace the TCM, refer to Transmission Control Module Removal procedure and Transmission Control Module Installation procedure. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Refer to Control Module References for TCM replacement, setup, and programming.
