GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Equinox 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 DTC C0460

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provide overview of each diagnostic category.

DTC Descriptor

DTC C0460 00: Steering Position Sensor

Circuit/System Description

The power steering control module (PSCM) continuously monitors the motor rotational sensor sinusoidal voltage signals. The sinusoidal voltage signals of the motor rotational sensor and the angle difference between the steering column output and input shafts detected by the torque sensor are both processed by the PSCM to detect and calculate the steering wheel angle.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The PSCM detects open, short to ground or short between any of the motor rotational sensor circuits.

Actions Taken When DTC Sets
    • DTC C0460 00 is stored in memory.
    • The driver information center (DIC) displays the SERVICE POWER STEERING message.
    • No steering assist.

Conditions for Clearing the DTC
    • A current DTC will clear on the next malfunction free ignition cycle.
    • A history DTC will clear after 100 consecutive malfunction-free ignition cycles.

Reference Information

Schematic Reference

Power Steering Schematics

Connector End View Reference

Power Steering Connector End Views

Description and Operation

Power Steering System Description and Operation

Electrical Information Reference

    •  Testing for Intermittent Conditions and Poor Connections
    •  Circuit Testing
    •  Connector Repairs
    •  Wiring Repairs

Scan Tool Reference

    •  Scan Tool Data Definitions
    •  Scan Tool Data List

Circuit/System Verification

Ignition ON, verify that scan tool parameter Steering Wheel Angle is +/- 90 degrees when turning steering wheel +/- 90 degrees.

Circuit/System Testing
  1. Ignition OFF, disconnect the C2 harness connector at the PSCM.
  2. Ignition OFF, test for 10-200 ohms of resistance between terminal 1 and terminal 3.
    3. ⇒If outside the specified range, test the exciting circuit and the exciting ground circuit for an open/high resistance or a short. If the circuits test normal, replace the electric power steering (EPS) motor.
  3. Ignition OFF, test for 3K-10K ohms of resistance between terminal 6 and terminal 3.
    4. ⇒If outside the specified range, test the SIN circuit and the exciting ground circuit for an open/high resistance or a short. If the circuits test normal, replace the EPS motor.
  4. Ignition OFF, test for 6K-20K ohms of resistance between terminal 5 and terminal 3.
    5. ⇒If outside the specified range, test the COS circuit and the exciting ground circuit for an open/high resistance or a short. If the circuits test normal, replace the EPS motor.
  5. Ignition OFF, test for greater than 1M ohms of resistance between terminal 3 and the motor flange.
    6. ⇒If less than the specified value, test the exciting ground circuit for a short to ground. If the circuit tests normal, replace the EPS motor.
  6. If all circuits test normal, test or replace the PSCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Control Module References
    •  Power Steering Assist Motor Replacement
    •  Electronic Power Steering Motor Control Module Replacement