GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Equinox 🢒 Body 🢒 Body Front End 🢒 Hood Hinge Replacement

Removal Procedure

    Object Number: 1360916 Size: SH

    Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

  1. Raise and support the hood.

    2. Object Number: 1360917 Size: SH
  2. Using a grease pencil, mark the position of the hood hinge.
  3. With an assistant to support the hood, remove the hinge bolts and the hinge.

Installation Procedure

    Object Number: 1360916 Size: SH
  1. With an assistant, position the hood hinge to the alignment marks on the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the hinge to hood bolts.

    3. Tighten
    Tighten the hinge to hood bolts to 25 N·m (18 lb ft).

  3. Slowly lower the hood.
  4. Inspect the hood alignment. Align the hood if necessary. Refer to Hood Adjustment .