GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Epica 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Rear Brake Hose Replacement

Removal Procedure

    Object Number: 1256206 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the brake line from the disc brake hose at the wheel housing bracket on each side of the vehicle.
  3. Remove the brake hose retainer.

    4. Object Number: 1256204 Size: SH
  4. Remove the rear disc brake hose retainer and the brake hose from the bracket on the steering knuckle shaft.

    5. Object Number: 1256207 Size: SH
  5. Remove the rear disc brake hose from the caliper.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1256207 Size: SH
  1. Install the rear disc brake hose to the caliper.

    2. Tighten
    Tighten the rear disc brake hose-to-caliper bolt to 32 N·m (24 lb ft).


    Object Number: 1256204 Size: SH
  2. Install the rear disc brake hose and the retainer on the bracket on the steering knuckle shaft.

    3. Object Number: 1256206 Size: SH
  3. Install the rear disc brake line to the brake hose on the wheel housing bracket.

    4. Tighten
    Tighten the brake line to fittings to 16 N·m (12 lb ft).

  4. Lower the vehicle.
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .
  6. Check the brake system for leaks.