1

Front Fender Emblem Assembly

Procedure

1. Use a J 25070 or equivalent to remove the old emblem.
2. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
4. Wipe the surface dry with a clean lint-free towel prior to installing new emblem.
5. Apply palm pressure to the emblem to ensure full adhesion is made to the fender.

Special Tools

J 25070 Heat Gun 500-700°F

1

Front Fender Emblem Assembly

Procedure

1. Use a J 25070 or equivalent to remove the old emblem.
2. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
4. Wipe the surface dry with a clean lint-free towel prior to installing new emblem.
5. Apply palm pressure to the emblem to ensure full adhesion is made to the fender.

Special Tools

J 25070 Heat Gun 500-700°F

1

Front Fender Emblem (Z06)

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Tip

1. Use J 25070 or equivalent to remove old fender emblem. Clean all adhesive from the fender, wipe surface dry with a clean lint-free towel prior to installing new emblem.
2. When removing the protective backing from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Align the tab on the backside of the emblem to the small notch located in the fender prior to adhesion.
4. Ensure full adhesion of the emblem is made to the front fender.