Front and Rear Bumper Fascia Emblem/Nameplate Replacement. Chevrolet Corvette 2009

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Front and Rear Bumper Fascia Emblem/Nameplate Replacement

Front and Rear Bumper Fascia Emblem/Nameplate Replacement ZR1 Front

Callout	Component Name
1	Front Bumper Fascia Emblem/Nameplate Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure Using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water clean the area where the emblem will be installed. Dry the area with a clean cotton lint-free towel. Peel the adhesive tape backing from the emblem. Position the emblem to the holes in the fascia to align emblem. Using palm pressure and a dry towel, wet out the adhesive tape backed emblem.

Callout

Component Name

Front Bumper Fascia Emblem/Nameplate

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water clean the area where the emblem will be installed.
Dry the area with a clean cotton lint-free towel.
Peel the adhesive tape backing from the emblem.
Position the emblem to the holes in the fascia to align emblem.
Using palm pressure and a dry towel, wet out the adhesive tape backed emblem.

Callout	Component Name
1	Front Bumper Fascia Emblem/Nameplate Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure Using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water clean the area where the emblem will be installed. Dry the area with a clean cotton lint-free towel. Peel the adhesive tape backing from the emblem. Position the emblem to the holes in the fascia to align emblem. Using palm pressure and a dry towel, wet out the adhesive tape backed emblem.

Callout

Component Name

Front Bumper Fascia Emblem/Nameplate

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water clean the area where the emblem will be installed.
Dry the area with a clean cotton lint-free towel.
Peel the adhesive tape backing from the emblem.
Position the emblem to the holes in the fascia to align emblem.
Using palm pressure and a dry towel, wet out the adhesive tape backed emblem.

Callout

Component Name

Front Fascia Emblem

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Tip

•	Clean the area where the emblem will be installed.

•	Use the holes in the fascia to align emblem.

Rear Fascia Emblem

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Tip

•	Clean the area where the emblem will be installed.

•	Use the holes in the fascia to align emblem.