GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Corvette 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.

    3. Object Number: 922511 Size: SH
  3. Remove the stabilizer shaft clamps, bolts and nuts retaining the shaft to the crossmember.
  4. Remove the stabilizer shaft insulators from the stabilizer shaft.

Installation Procedure

    Object Number: 922511 Size: SH
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft insulator clamps on the stabilizer shaft.

    3. Caution: Refer to Fastener Caution in the Preface section.

    Note: When installing the upper bolts and lower nuts, hand tighten them to hold the stabilizer shaft in place.

  3. Install the upper stabilizer shaft bolts and tighten to 150 N·m (111 lb ft).
  4. Install the lower stabilizer shaft nuts and tighten to 95 N·m (70 lb ft).
  5. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.