Circuit Description
The engine control module (ECM) creates the engine speed signal by pulsing the signal circuit to ground at the rate of 2 pulses per engine revolution. The instrument panel cluster (IPC) converts the signal to a tachometer position. The IPC also receives a class 2 message from the ECM indicating the engine speed. The IPC uses this class 2 message for diagnostic purposes.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B0560 Tachometer Circuit
Conditions for Running the DTC
| • | The IPC receives a class 2 message from the ECM indicating that the engine speed is greater than 800 RPM. |
| • | The ignition voltage is between 9-18 volts. |
Conditions for Setting the DTC
| • | The IPC does not detect a 2 pulses per engine revolution signal on the engine speed signal circuit. |
| • | The above condition is present for at least 5 seconds. |
Action Taken When the DTC Sets
The IPC stores a DTC B0560 in memory.
Conditions for Clearing the DTC
| • | A history DTC clears after 100 malfunction free warm-up cycles. |
| • | The DTC becomes history when the conditions for setting the DTC are no longer present. |
| • | The IPC receives the clear code command from the scan tool. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Master Electrical Component List | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 |
Does the Engine Speed parameter match the tachometer display? | -- | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 |
Does the voltage measure greater than the specified value? | 9 V | Go to Step 4 | Go to Step 5 |
4 | Test the engine speed signal circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 6 |
5 | Test the engine speed signal circuit for an open or for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the ECM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
8 | Replace the ECM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 10 | -- |
9 | Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 10 | -- |
10 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
