GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Corvette 🢒 Bulletins 🢒 SMU - Revised Console Trim Panel Replacement - Right and Instrument Panel Accessory Trim Plate Replacement

SMU - Revised Console Trim Panel Replacement - Right and Instrument Panel Accessory Trim Plate Replacement

Subject:Revised Console Trim Panel Replacement-Right and Instrument Panel Accessory Trim Plate Replacement

Models:2005-2006 Chevrolet Corvette


This bulletin is being issued to revise the Console Trim Panel Replacement-Right procedure and the Instrument Panel Accessory Trim Plate Replacement procedure in the Instrument Panel, Gauges and Console sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Console Trim Plate Replacement -- Right
Object Number: 1567084 Size: SF

Callout

Component Name

Notice: Refer to Fastener Notice in Cautions and Notices.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

1

Emergency Brake Lever Bezel

2

Console Trim Panel Screws (Qty: 2)

Tighten
2 N·m (18 lb in)

3

Console Trim Panel

4

Console Trim Panel Clip (Qty: 2)

Instrument Panel Accessory Trim Plate Replacement
Object Number: 1469880 Size: LF

Callout

Component Name

Notice: Refer to Fastener Notice.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedure

Remove the right console trim panel. Refer to Console Trim Panel Replacement - Right.

1

Floor Console Trim Plate Assembly

Tip

  1. Grasp the back edge of the trim and lift upward releasing the clips.
  2. Disconnect the electrical connections.

2

Retainer Clips (Qty: 2)

3

Instrument Panel Accessory Trim Plate Bolt (Qty: 2)

Tighten
3 N·m (27 lb in)

4

Instrument Panel Accessory Trim Plate Assembly

Tip

  1. Grasp the back edge of the trim and lift upward and rearward releasing the clips.
  2. Disconnect all electrical connections.

5

Clip, Plate Assembly - Instrument Panel Accessory Trim (Qty: 6)