1. Raise the seat to the full up position.
2. Remove the seat. Refer to Driver and Passenger Seat Replacement .
3. Remove the seat cushion cover. Refer to Seat, Cushion, Cover, Pad Replacement - Front Seat



4. Remove the hinge pin nuts and the hinge pins.
5. Lay the seat back down.
6. Remove the cables from the actuators.



7. Remove the seat from the adjuster to access the recliner mechanism attaching screws.



8. Remove the screws attaching the recliner mechanism.
9. Remove the recliner mechanism.

Important: Do not lubricate the seat back recliner mechanism.

1. Install the recliner mechanism to the seat frame.
2. Install the cables to the actuators.
3. Securely snap the cable retaining clips to the actuators with the tabs up.



4. Install the seat adjusters to the seat, if removed.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Apply Loctite™ 271 to the bolts and secure the adjuster to the seat.

Tighten
Tighten the bolts to 24 N·m (18 lb in).





Important: Use a tread locking compound on the hinge bolts.

6. Install the hinge bolts, seat back release cables, and nuts.

Tighten
Tighten the hinge bolt nuts to 24 N·m (18 lb ft).

7. Install the seat cushion trim cover. Refer to Seat, Cushion, Cover, Pad Replacement - Front Seat .
8. Install the side trim panel. Refer to Handle, Knob, Switch, Side Shield Replacement - Front Seat .



9. Install the seat. Refer to Driver and Passenger Seat Replacement .