For 1990-2009 cars only
Tools Required
| • | DT-48007 Spline Holder |
| • | J 42164 Getrag Axle Pinion Gear Holder |
| • | J 42170 Getrag Axle Bearing Race Installer |
| • | J 42172 Getrag Axle Bearing Race Installer |
- Install the bearing onto the pinion shaft using the J 42170 (1), J 42164 (2) or DT-48007 (2), and a hydraulic press.
- Assemble the pinion shaft (5), spacer (3), and bearing (2) into the housing/cage (4).
- Press the bearing onto the pinion shaft using the J 42170 (1), J 42164 (2) or DT-48007 (2), and a hydraulic press.
- Install the nut onto the pinion shaft using a torque wrench, the J 42172 (1), and the J 42164 (2) or DT-48007 (2).
- Using a punch, stake the areas of the nut into the notches in the end of the pinion shaft.
- Measure the rotating torque of the pinion shaft using the J 42164 . A properly assembled pinion shaft and bearings should have a rotating torque of 1.4-2.8 N·m (12-25 lb in).
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nut to 500 N·m (370 lb ft).
