Tools Required

J 41712 Oil Pressure Sensor Socket

1. Remove the left engine sight cover. Refer to Upper Intake Manifold Sight Shield Replacement .
2. Clean area around the oil sensor/switch before removing it.
3. Remove the vacuum hose for the power brake booster.



4. Disconnect the electrical connector for the oil pressure sensor/switch (2).



5. Using the J 41712 (1) , remove the oil pressure sensor/switch.

1. If installing the old sensor, apply threadlocker sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.

Notice: Refer to Fastener Notice in the Preface section.

2. Using the J 41712 (1), install the oil pressure sensor/switch.

Tighten
Tighten the engine oil pressure sensor to 20 N·m (15 lb ft).




3. Reconnect the oil pressure sensor/switch electrical connector (2).



4. Install the vacuum hose for the power brake booster.
5. Install the left engine sight cover. Refer to Upper Intake Manifold Sight Shield Replacement .