For 1990-2009 cars only
Removal Procedure
- Remove the upper and lower steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
- Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Remove the 2 pan head tapping screws (1).
- Remove the multifunction turn signal switch assembly (1).
Installation Procedure
- Install the multifunction turn signal switch assembly (1) to the steering column assembly.
- Install the 2 pan head tapping screws (1).
- Route the wire harness assembly along the steering column jacket assembly.
- Install the wire harness assembly (1) into the wire harness strap (2).
- Install new wire harness straps (2) to the steering column assembly (1) and the column.
- Install the upper and lower steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
Important: The electrical contact must rest on the turn signal cancel cam assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 6 N·m (53 lb in).
