GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Corvette 🢒 Body and Accessories 🢒 Instrument Panel, Gages, and Console 🢒 Head Up Display Switch Replacement

Removal Procedure

    Object Number: 95725 Size: SH
  1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Cluster Replacement .
  2. Disconnect the electrical connector on the dimmer/head-up display (HUD) switch on the instrument panel (IP).

    3. Object Number: 95726 Size: SH
  3. Disconnect the electrical connector from the driver information center (DIC) switch.

    4. Object Number: 95724 Size: SH
  4. Remove the IPC bezel retaining screws.
  5. Remove the bezel from the IPC.

    6. Object Number: 95722 Size: SH
  6. Remove the retaining screws from the IP dimmer/HUD switch.
  7. Remove the IP dimmer/HUD switch.

Installation Procedure

    Object Number: 95722 Size: SH
  1. Install the IP dimmer/HUD switch to the IPC bezel.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the retaining screws to the IP dimmer/HUD switch.

    3. Tighten
    Tighten the retaining screws to 1.5 N·m (13 lb in).


    Object Number: 95724 Size: SH
  3. Install the bezel to the IPC. Align the bezel onto the guide pins.
  4. Install the IPC bezel retaining screws.

    5. Tighten
    Tighten the retaining screws to 1.5 N·m (13 lb in).


    Object Number: 95725 Size: SH
  5. Connect the electrical connector to the IP dimmer/HUD switch.

    6. Object Number: 95726 Size: SH
  6. Connect the DIC switch electrical connector.
  7. Install the IPC to the vehicle. Refer to Instrument Cluster Replacement .