Tools Required

J 25070 Heat Gun

1. When replacing an body side molding, do the following:

1.1.	Use tape to protect the mounting surface during removal.

1.2.	Use tape for alignment marks for installation of the body side molding.

2. To remove an body side molding, heat the body side molding using a J 25070 .
3. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Use a plastic, flat-bladed tool to remove the body side molding from the panel surface.

1. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
2. Ensure that the temperature of the body side molding is approximately 29-32°C (85-90°F).

Important: Do not touch the adhesive backing on the body side molding.

3. Remove the protective liner from the back of the body side molding.
4. Position the molding to the following dimensions.

•	Forward of the rear edge of the fender 3 mm (0.1 in)

•	In line with the door molding

5. Apply equal pressure along the body side molding to uniformly bond the item to the mounting surface.
6. Remove the protective tape from the mounting surface.