For 1990-2009 cars only
- Raise and suitably support the vehicle; ensure that the vehicle is level. Refer to Lifting and Jacking the Vehicle in General Information.
- Clean any dirt from around the fill plug hole.
- Remove the transmission fluid fill plug hole.
- If equipped, disconnect the transmission fluid temperature (TFT) sensor electrical connector.
- Clean any dirt from around the TFT sensor.
- If equipped, remove the TFT sensor from the transmission.
- Inspect the transmission fluid level, ensure that the fluid level is even with the bottom of the fill plug hole.
- Add Dexron® - III transmission fluid, if necessary.
- If equipped, install the TFT sensor to the transmission.
- If equipped, connect the TFT sensor electrical connector.
- Install the transmission fluid fill plug hole.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the TFT sensor to 27 N·m (20 lb ft).
Tighten
Tighten the transmission fluid fill plug hole to 27 N·m
(20 lb ft).
