- Adjust the latch handle (1) for proper fit, by raising or lowering the striker (3).
- Use a nylon mallet and a drift to punch the striker (3). Punch upward to loosen the striker or punch downward to tighten the striker.
- Inspect the striker screws for proper torque.
- Loosen the latch handle bolts.
- Reposition the latch handle forward or rearward. To avoid squeaks and rattles maintain a minimum of 2 mm (0.08 in) clearance between latch handle and the latch striker.
- Tighten the latch handle bolts.
Important: You should not have to loosen the striker screws.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the striker screws 10 N·m (89 lb in).
Important: Assure that the latch handle base is parallel to the striker.
Tighten
Tighten the bolts to 13 N·m (10 lb ft).
