For 1990-2009 cars only
Removal Procedure
- Remove the windshield side garnish moldings. Refer to Windshield Side Garnish Molding Replacement .
- Remove the rear compartment front side trim panels. Refer to Rear Compartment Side Trim Panel Replacement .
- Support the headlining.
- Remove the retainer from the center of the rear edge of the headlining.
- Remove the sunshades. Refer to Sunshade Replacement in Interior Trim.
- Remove the sunshade bezels.
- Remove the sunshade supports.
- Remove the headlining.
Installation Procedure
- Install the headlining to the vehicle.
- Support the headlining.
- Install the retainer securing the rear edge of the headlining.
- Route the sunshade electrical connection through the headlining and the sunshade bezel.
- Install the sunshade bezels.
- Install the sunshades. Refer to Sunshade Replacement in Interior Trim.
- Install the sunshade retainers.
- Remove the headlining temporary support.
- Install the windshield side garnish moldings.
- Install the rear compartment front side trim panels. Refer to Rear Compartment Side Trim Panel Replacement .
- Reposition the inside lip of the door window upper weatherstrips over the edge of the headlining.
Insert the bezel into the opening until the snap fingers engage.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sunshade retainer screws to 2 N·m (17 lb in).
