For 1990-2009 cars only
Removal Procedure
- Remove the lock pillar upper trim panel. Refer to Body Lock Pillar Trim Panel Replacement in Interior Trim.
- Position the #1 bow and the #5 bow in an up position.
- Disconnect the rear defogger electrical connections.
- Using a grease pencil mark the folding top mounting locations on both sides.
- With an assistant remove the bolts which secure the folding top to the pillar bracket.
- With an assistant slide the top slightly up and then rearward and out of the pillar bracket.
Installation Procedure
- Position the folded top to the vehicle with the top resting on the pillar bracket pin.
- Align the folding top to the marks made upon removal.
- Install the folding top bolts to the body.
- Close and latch the top.
- Connect the rear defogger electrical connections.
- Install the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement in Interior Trim.
- Check top for proper operation.
- Water test the folding top. Refer to Generalized Testing in Water Leaks.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
