Before removing the weatherstrip attempt to repair the waterleak by adjusting or shimming: the weatherstrip, the door, the door glass, the folding top, or the panel.

If the weatherstrip is removed the weatherstrip should be replaced.

1. Pull the weatherstrip from the retainer while cutting through the adhesive with a spatula.

•	Most weatherstrips are bonded to the retainers with adhesive.

•	Try not to tear the weatherstrip, keeping the weatherstrip intact aids in removal.

2. Remove all the old adhesive from the retainer or remove the retainer.

Important: Most retainers are backed with foam sealing tape. To avoid scratching an acrylic roof panel do not use a scraper to remove the foam sealing tape adhesive from the panel.

3. If a weatherstrip retainer is removed, remove all the old foam sealing tape and adhesive from the mating surface.
4. Remove any broken screws.

1. Install the retainer if removed.

•	Insure the retainer is backed with foam sealing tape if required.

•	Replace any stripped screws.

•	Lubricate the screws before installation to prevent breaking the screws.

2. Apply a continuous 3 mm (0.125 in) bead of weatherstrip adhesive inside the center of the weatherstrip retainer. Apply an extra amount at each end of the retainer.
3. Install the weatherstrip using a nylon spatula.
4. Finesse the weatherstrip at joints to ensure a proper fit. Use thumb grade sealer as necessary.
5. Allow the adhesive to cure before rechecking for water leaks.