GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Corvette 🢒 Body and Accessories 🢒 Body Rear End 🢒 Weatherstrip Retainer Replacement

Removal Procedure

    Object Number: 376671 Size: SH
  1. Remove the push-in retainer securing the lower end of the weatherstrip to the lock pillar.
  2. Remove the door opening weatherstrip from the lock pillar retainer
  3. Remove the door opening weatherstrip from the roof retainer from the lock pillar to the windshield.

    4. Object Number: 376675 Size: SH
  4. Remove the screws securing the lock pillar retainer.
  5. Remove the lock pillar retainer.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 376675 Size: SH
  1. Install the lock pillar retainer.

    2. Tighten
    Tighten the lock pillar weatherstrip retainer screws to 3 N·m (27 lb in).

  2. Apply a 6 mm (0.25 in) x 100 mm (4 in) bead of sealer across the lower edge of the retainer and onto the lock pillar.
  3. Install the weatherstrip. Refer to Weatherstrip Replacement in Stationary Windows.