Removal Procedure
- Remove the door trim panel. Refer to Door Trim Panel Replacement in Doors.
- Disconnect the electrical/audio connector from the front door radio speaker assembly.
- Remove the screws retaining the front door speaker assembly to the door.
- Remove the front door speaker assembly.
Important: The speaker assembly is only held in place by retaining screws. Be sure to support the speaker assembly upon removal.
Installation Procedure
- Install the front door speaker assembly into position in the door.
- Install the front door speaker assembly retaining screws in the following sequence:
- Connect the electrical/audio connector to the front door speaker assembly.
- Install the door trim panel. Refer to Door Trim Panel Replacement in Doors.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: The tightening sequence MUST be followed.
| 2.1. | The uppermost screw |
| 2.2. | The lowermost screw |
| 2.3. | The remaining screws in a criss-cross pattern |
Tighten
Tighten the front door speaker assembly retaining screws in sequence
to 2.5 N·m (22 lb in).
