GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Corvette 🢒 Brakes 🢒 Antilock Brake System 🢒 Vehicle Yaw Sensor Replacement

Removal Procedure

    Object Number: 304387 Size: MH
  1. Turn the ignition switch to the OFF position.
  2. Remove the IP Accessory Trim Plate refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  3. Disconnect the Yaw Rate Sensor connector.
  4. Loosen the two Yaw Rate Sensor nuts (1).
  5. Remove the Yaw Rate Sensor (2).

Installation Procedure

    Object Number: 304387 Size: MH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the Yaw Rate Sensor (2) onto the Yaw Rate Sensor Bracket.

    2. Tighten
    Tighten the two Yaw Rate Sensor nuts (1) to 6 N·m (5 lb ft).

  2. Connect the Yaw Rate Sensor connector.
  3. Install the IP Accessory Trim Plate refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
  4. Turn the ignition switch to the ON position, engine off.
  5. Perform the Diagnostic System Check - ABS .