Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.

1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1), or equivalent; do NOT disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement .



2. Remove the brake pads (2) from the brake caliper bracket (3).
3. Remove the brake pad retainers (1) from the brake caliper bracket (3).

Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.




4. Remove the brake caliper mounting bracket bolts and washers.
5. Discard the brake caliper mounting bracket bolts.
6. Remove the brake caliper mounting bracket from the knuckle.
7. Inspect the brake caliper bracket.
8. Replace the brake caliper bracket if cracked or damaged.
9. Clean all the bolt adhesive residue from the brake caliper mounting bracket and the knuckle mating surfaces.

1. Install the brake caliper mounting bracket to the knuckle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the two NEW brake caliper mounting bracket bolts and washers.

The new brake caliper mounting bracket bolts will come with an adhesive already applied to the threads.

Tighten
Tighten the front brake caliper mounting bracket bolts to 175 N·m (125 lb ft).

3. Lubricate the brake caliper pin bolts with high temperature silicone lubricant.



4. Install the brake pad retainers (1) to the brake caliper bracket (3).
5. Install the brake pads (2) to the brake caliper bracket (3).
6. Install the brake caliper. Refer to Front Brake Caliper Replacement .