GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Corvette 🢒 Engine 🢒 Engine Electrical 🢒 DTC P0601, P0602, P0603, P0604, P0605, P0606, P0607, P1600, P1621, P1627, P1680, P1681, P1683, or P2610

Description

This diagnostic applies to internal microprocessor integrity conditions within the control module. This diagnostic also addresses if the control module is not programmed. The following DTCs are diagnosed in this DTC table:

    • DTC P0601
    • DTC P0602
    • DTC P0604
    • DTC P0606
    • DTC P1683

Diagnostic Aids

For complete details on programming the PCM, refer to Powertrain Control Module Programming .

Test Description

The number below refers to the step number on the diagnostic table.

  1. A DTC P0602 indicates the PCM that is not programmed.

DTC P0601-P0607, P1600, P1621, P1627, or P1683

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check-Engine Controls?

Go to Step 2

Go to Diagnostic System Check - Engine Controls

2

Is DTC P0602 set?

Go to Step 3

Go to Step 5

3

Program the PCM. Refer to Powertrain Control Module Programming .

Does DTC P0602 reset?

Go to Step 4

Go to Step 6

4
  1. Ensure that all tool connections are secure.
  2. Ensure the programming equipment is operating correctly.
  3. Ensure the correct software/calibration package is used.
  4. Attempt to program the PCM. Refer to Powertrain Control Module Programming .

Does DTC P0602 reset?

Go to Step 5

Go to Step 6

5

Replace the PCM. Refer to Powertrain Control Module Replacement .

Did you complete the replacement?

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.

Does the DTC run and pass?

Go to Step 7

Go to Step 2

7

With a scan tool, observe the stored information, Capture Info.

Does the scan tool display any DTCs that you have not diagnosed?

Go to Diagnostic Trouble Code (DTC) List

System OK