Removal Procedure
- Disconnect the mass air flow (MAF) sensor electrical connector, if necessary.
- Remove the engine wiring harness from the clip on the radiator shroud.
- Remove the air cleaner intake duct.
- Remove the radiator support bolts.
- Remove the radiator support.
Important: Note the position of the radiator upper support in relationship to the fan shroud. This must be reassembled correctly in order to retain the fan shroud.
Installation Procedure
- Install the radiator support.
- Position the radiator support between the plastic guides located on the top center of the fan shroud.
- Install the radiator support bolts.
- Tuck the outboard corners of the lower cooling baffle under the radiator support until it locks into place.
- Install the air cleaner intake duct.
- Install the engine wiring harness to the clip on the radiator shroud.
- Connect the MAF sensor electrical connector.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the radiator support bolts to 8 N·m (71 lb in).
Important: Seat the air cleaner retaining grommets fully. If necessary moisten the grommets with water prior to installation.
