Creak from Steering Wheel
Symptom
Creak when turning the steering wheel.
Possible Cause
The steering wheel surround tabs are moving on the steering wheel hub.
Diagnosis
Road test at a very slow speed turning the steering wheel from lock
to lock while pushing and pulling on the rim of the steering wheel.
Corrective Action
- Remove the drivers inflator module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
- Spread the surround tabs and remove the surround from the hub.
- Lubricate the steering wheel hub where the tabs make contact and
also lubricate the cover edges at the spokes with a petroleum free lubricant
GM P/N 12345579, or equivalent.
- Reinstall the surround and the inflator module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
in SIR.
Itch from Instrument Cluster Bezel
Symptom
Itch from the instrument panel cluster.
Possible Cause
The lower right hand cluster lens snap hook is not securing the lens
allowing the lens to rub against the cluster bezel.
Diagnosis
Road test and apply pressure to the lower right hand corner of the lens
and listen for itch to go away.
Corrective Action
- Remove the cluster. Refer to
Instrument Cluster Replacement
in Instrument Panel, Gauges and
Console.
- Remove the bezel from the cluster. Refer to
Instrument Panel Cluster Trim Plate Bezel Replacement
in Instrument Panel, Gauges and
Console.
- Fully engage the lower right hand snap hook and glue a 1.7 mm
(1/16 in) thick shim under the snap fit hook to secure the lens.
- Install the cluster. Refer to
Instrument Panel Cluster Trim Plate Bezel Replacement
in Instrument Panel, Gauges and Console.
Glove Box Door Rattle
Symptom
An itch or rattle from the glove box door area.
Possible Cause
The glove box door is out of adjustment.
Diagnosis
Road test the vehicle per the customers description of when the itch
or rattle happens.
Corrective Action
Adjust the glove box door striker. Refer to
Instrument Panel Compartment Door Lock Striker Adjustment
in Instrument Panel Gauges and Console.
Rattle from the Forward Outer Edge of the Instrument Panel Pad
Symptom
Rattle from the forward edge of the instrument I/P panel pad.
Possible Cause
Not enough insulator foam between the instrument panel and the pad.
Diagnosis
Road test and apply hand pressure to the forward edge of the instrument
panel pad to find the location of the rattle.
Corrective Action
- Remove the Instrument panel pad. Refer to
Instrument Panel Upper Trim Pad Replacement
in Instrument Panel, Gauges and
Console.
- Install added insulation at the point of rattle to the underside
of the pad.
- Install the I/P pad. Refer to
Instrument Panel Upper Trim Pad Replacement
in Instrument Panel, Gauges and Console.
Squeak in Brake Pedal
Symptom
Squeak in the brake pedal.
Possible Cause
Lack of lubricant in the brake pedal pivot.
Diagnosis
Apply pressure to the brake pedal and listen for squeak.
Corrective Action
Lubricate the brake pedal pivot pin.
Rattle from Sunshade
Symptom
Rattle from the sunshade.
Possible Cause
The sunshade rod end is vibrating in the retention clip.
Diagnosis
Road test and apply pressure to the sunshade and listen for noise to
change.
Corrective Action
Replace the retention clip tightening the screw to 2 N·m
17 lb in).
Rattle from Windshield Header
Symptom
Rattle from the windshield header.
Possible Cause
The rear view mirror is vibrating on the mirror mounting support.
Diagnosis
Road test and apply pressure to the mirror and listen for the noise
to change.
Corrective Action
- Tighten the mirror mount tension screw. Refer to
Fastener Tightening Specifications
in Stationary Windows.
- If the rattle still exist, replace the mirror.