Removal Procedure
- Disconnect the refrigerant pressure sensor electrical connector.
- Remove the pressure sensor (1) from the evaporator tube - front.
- Remove and discard the O-ring seal from the sensor port on the evaporator tube - front.
Installation Procedure
- Using a lint-free clean, dry cloth, carefully clean the sealing surfaces of the sensor port on the evaporator tube - front and the refrigerant pressure sensor.
- Lightly coat the new O-ring seal with mineral base 525 viscosity refrigerant oil.
- Carefully slide the new O-ring seal onto the sensor port on the evaporator tube - front until seated.
- Install the pressure sensor (1) to the evaporator tube - front.
- Connect the pressure sensor electrical connector.
Important: DO NOT allow any of the mineral base 525 viscosity refrigerant oil on the O-ring seal to enter the refrigerant system.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the refrigerant pressure sensor to 4.75 N·m (42 lb in).
