GM Service Manual Online
For 1990-2009 cars only

Blower Motor Is Inoperative At Low Speed (Position 1)<<C60>>

Step

Action

Value(s)

Yes

No

DEFINITION: Blower motor will operate at all speeds except Low speed (Position 1).

1

Were you sent here from the HVAC Diagnostic System Check (C60)?

--

Go to Step 2

Go to Diagnostic System Check

2

  1. Disconnect the HVAC Control Assembly connector C2.
  2. Disconnect the blower motor control module connector C1.
  3. Connect a fused jumper wire between terminal B and terminal H of the HVAC Control Assembly connector C2.
  4. Turn the ignition switch to the ON position.
  5. Connect a test light between terminal B of the blower motor control module connector C1 and ground.

Does the test light illuminate?

--

Go to Step 4

Go to Step 3

3

Locate and repair the open or high resistance in CKT 60.

Is the repair complete?

--

Go to Step 7

--

4

  1. Remove the fused jumper wire.
  2. Connect the HVAC Control Assembly connector C2.
  3. Turn the blower switch to the Low position.
  4. Turn the ignition switch to the ON position.
  5. Connect a test light between terminal B of the blower motor control module connector C1 and ground.

Does the test light illuminate?

--

Go to Step 6

Go to Step 5

5

Replace the HVAC Control Assembly. Refer to Control Assembly Replacement .

Is the repair complete?

--

Go to Step 7

--

6

Replace the blower motor control module. Refer to Blower Motor Resistor Replacement .

Is the repair complete?

--

Go to Step 7

--

7

  1. Clear any DTCs which may have set. Refer to Diagnostic Trouble Code (DTC) Clearing .
  2. Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Diagnostic System Check