GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Body and Accessories 🢒 Body Front End 🢒 Hood Stop and Bracket Replacement

Removal Procedure

    Object Number: 71255 Size: SH
  1. Remove the front fender. Refer to Front Fender Replacement .

    2. Object Number: 71272 Size: SH
  2. Remove the bolts attaching the hood stop bracket to the hood stop. On the passenger side one of the bolts also attaches to the plenum bracket.

    3. Object Number: 71273 Size: SH
  3. Remove the bolts attaching the hood stop bracket to the hinge pillar.

    4. Object Number: 71274 Size: SH
  4. Transfer the hood bumper if necessary.

Installation Procedure

    Object Number: 71273 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the hood stop bracket to the hinge pillar.

    2. Tighten
    Tighten the hood stop bracket bolts to 25 N·m (18 lb ft).


    Object Number: 71272 Size: SH
  2. Install the hood stop (and the plenum bracket on the passenger side) to the hood stop bracket.

    3. Tighten
    Tighten the hood stop bracket bolts to 25 N·m (18 lb ft).


    Object Number: 71274 Size: SH
  3. Install the hood bumper.

    4. Tighten
    Tighten the hood bumper jam nut to 10 N·m (89 lb in).


    Object Number: 71255 Size: SH
  4. Install the fender. Refer to Front Fender Replacement .