For 1990-2009 cars only
Removal Procedure
- Place the transmitter (2) face down on a clean surface.
- Insert a small screwdriver or coin into the slot (1) on the side of the transmitter.
- Carefully turn the screwdriver in the slot until the cover releases.
- Remove the cover while being careful not to damage the seal.
- Remove the battery from the transmitter.
Installation Procedure
- Install the new battery (CR 2450 or equivalent) (2) with the positive (+) side facing up.
- Inspect that the seal is properly positioned.
- Snap the two halves together (1) (3).
- Synchronize the transmitter to the receiver. Refer to Transmitter Programming/Synchronization .
