GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Front Fog Lamp Bulb Replacement

Removal Procedure

    Object Number: 171878 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, then reposition the duct.

    4. Object Number: 64629 Size: SH
  4. Disconnect the front fog lamp electrical connector.

    5. Object Number: 64630 Size: SH

    Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

       • Turn off the lamp switch and allow the bulb to cool before changing the bulb.
       • Leave the lamp switch OFF until the bulb change is complete.
       • Always wear eye protection when changing a halogen bulb.
       • Handle the bulb only by its base. Avoid touching the glass.
       • Keep dirt and moisture off the bulb.
       • Properly dispose of the used bulb.
       • Keep halogen bulbs out of the reach of children.

  5. Remove the fog lamp bulb from the fog lamp.

    6. Twist the bulb to release.

Installation Procedure

    Object Number: 64630 Size: SH

    Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

       • Turn off the lamp switch and allow the bulb to cool before changing the bulb.
       • Leave the lamp switch OFF until the bulb change is complete.
       • Always wear eye protection when changing a halogen bulb.
       • Handle the bulb only by its base. Avoid touching the glass.
       • Keep dirt and moisture off the bulb.
       • Properly dispose of the used bulb.
       • Keep halogen bulbs out of the reach of children.

  1. Install the fog lamp bulb to the fog lamp assembly.

    2. Twist the bulb to secure.


    Object Number: 64629 Size: SH
  2. Connect the front fog lamp electrical connector.

    3. Object Number: 171878 Size: SH
  3. Position the brake caliper cooling duct to the front fascia, then push to secure.
  4. Install the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
  5. Lower the vehicle.
  6. Verify that the front fog lamps are aimed properly. Refer to Fog Lamp Aiming .