GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Rear Fog Lamp Replacement

Removal Procedure

    Object Number: 95549 Size: SH
  1. Remove the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement .
  2. Remove the rear fog lamp socket from the rear fog lamp assembly.

    3. Access the rear fog lamp through the tail lamp opening.


    Object Number: 95547 Size: SH
  3. Remove the rear fog lamp bezel retaining nut and support the lamp assembly.
  4. Remove the bezel from the lamp.

    5. Lift the bezel off of the stud and pivot it out of the slot on the lamp.

  5. Remove the rear fog lamp assembly.

Installation Procedure

    Object Number: 95547 Size: SH
  1. Position the rear fog lamp assembly to the rear fascia.
  2. Install the bezel to the lamp.

    3. Insert the bezel into the slot on the lamp, then pivot the bezel onto the stud.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the rear fog lamp bezel retaining nut.

    4. Tighten
    Tighten the rear fog lamp bezel retaining nut to 2 N·m (18 lb in).


    Object Number: 95549 Size: SH
  4. Install the socket to the lamp.
  5. Install the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement .