Were you sent here from the Headlight System Check?

--

Go to Step 2

Go to Headlight System Check

1. Remove the HDLP MaxiCircuit Breaker #54.
2. Disconnect connector C209.
3. Using a DMM measure the resistance to ground of circuit 842, from the harness side connector C209 terminal W to ground.

Is the resistance within specified values?

Infinite

Go to Step 3

Go to Step 10

1. Connect a DMM from the HDLP MaxiCircuit Breaker #54 terminal in the instrument panel electrical center, to connector C209 terminal W.
2. Measure the resistance of circuit 842.

Is the resistance within specified values?

0-2 ohms

Go to Step 4

Go to Step 10

Measure continuity of the HDLP MaxiCircuit Breaker #54.

Is the circuit breaker open?

--

Go to Step 6

Go to Step 5

Reinstall the HDLP MaxiCircuit Breaker #54 in the instrument panel electrical center.

Is the repair complete?

--

Go to Step 7

--

Install a new 20 A MaxiCircuit Breaker in the HDLP #54 location in the instrument panel electrical center.

Is the repair complete?

--

Go to Step 7

--

Connect a fused jumper wire in the harness side connector C209 terminals W to L.

Do the low beam headlamps illuminate?

--

Go to Step 12

Go to Step 8

Connect a fused jumper wire in the harness side connector C209 terminals W to K.

Do the high beam headlamps illuminate?

--

Go to Step 11

Go to Step 9

Replace the headlamp switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the repair complete?

--

Go to Headlight System Check

--

Repair the open or short to ground in circuit 842.

Is the repair complete?

--

Go to Headlight System Check

--

Repair the open or short to ground in circuit 11.

Is the repair complete.

--

Go to Headlight System Check

--

Repair the open or short to ground in circuit 12.

Is the repair complete.

--

Go to Headlight System Check

--