For 1990-2009 cars only
Removal Procedure
- Remove the passenger side front floor kick up panel cover to access the instrument panel (IP) electrical center.
- Remove the headlamp circuit breaker from the IP electrical center.
- Open the hood.
- Raise the RH headlamp manually.
- Turn the headlamp motor/actuator manual control knob counterclockwise to raise the headlamp.
- Disconnect the RH headlamp wiring harness electrical connector from the forward lamp wiring harness.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
- Release the brake caliper cooling duct from the front fascia and reposition the duct.
- Disconnect the electrical connectors from the headlamp control module.
- Remove the nuts mounting the module to the headlamp bracket.
- Remove the module from the vehicle.
Installation Procedure
- Install the headlamp control module into position on the headlamp bracket.
- Install the nuts mounting the module to the headlamp bracket.
- Connect the electrical connectors to the module.
- Position the brake caliper cooling duct to the front fascia and push to secure.
- Install the front fascia lower closeout panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement in Bumpers.
- Lower the vehicle.
- Connect the RH headlamp wiring harness electrical connector to the forward lamp wiring harness.
- Lower the RH headlamp manually.
- Install the headlamp circuit breaker into the IP electrical center.
- Install the floor kick up panel covering the IP electrical center.
- Close the hood.
Turn the headlamp motor/actuator manual control knob clockwise to lower the headlamp.
