Notice: Whenever the Instrument Panel Cluster (IPC) is removed from the vehicle, DO NOT set the IPC on its face for more than 15 minutes or damage to the fluid filled air core gages may result.

1. Remove the instrument panel cluster (IPC) from the vehicle. Refer to Instrument Cluster Replacement .
2. Disconnect the instrument panel (IP) dimmer switch electrical connector.



3. Disconnect the driver information center (DIC) switch electrical connector.



4. Remove the IP cluster bezel retaining screws.
5. Remove the bezel from the IPC.



6. Remove the IP dimmer switch retaining screws.
7. Remove the IP dimmer switch.

1. Install the IP dimmer switch to the IP cluster bezel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the IP dimmer switch retaining screws.

Tighten
Tighten the IP dimmer switch retaining screws to 1.5 N·m (13 lb in).




3. Install the bezel to the IPC.

Align the bezel onto the guide pins.

4. Install the IP cluster bezel retaining screws.

Tighten
Tighten the instrument panel cluster bezel retaining screws to 1.5 N·m (13 lb in).




5. Connect the IP dimmer switch electrical connector.



6. Connect the DIC switch electrical connector.
7. Install the IPC to the vehicle. Refer to Instrument Cluster Replacement .