1

1. Turn the ignition switch to the off position.
2. Install the scan tool.
3. Turn the ignition switch to the on position.
4. Select display DTC function with the scan tool.
5. Check for any DTCs related to either door, seat, or steering column operation.

No DTCs are stored in memory or current status.

2

1. Turn the ignition to the off position.
2. Remove the scan tool from the diagnostic link connector.
3. Check the telescoping steering column operation by operating the switch in the in and out positions.

The telescoping steering column moves in and out.

3

1. Turn the ignition switch to the on position.
2. Engine is off, vehicle is in park/neutral and not moving.
3. Move the telescoping steering column to the full in position.
4. Depress and hold the Memory 1 button until the memory indicator flashes once.
5. Move the telescoping steering column to the full out position.
6. Depress and hold the Memory 2 button until the memory indicator flashes once.
7. Choose one other steering column position between the two previous settings.
8. Depress and hold both the Memory 1 and Memory 2 buttons until the memory indicators flash once.

4

Test the Memory functions.

1. Depress the Memory 1 button.
2. Depress the Memory 2 button.
3. Depress the Memory 1 and the Memory 2 buttons simultaneously.

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.