Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.

1. Turn the ignition switch to the OFF position.
2. Disconnect the EBTCM harness connector.
3. Remove the three insulator nuts (2) (3).
4. Lift the EBTCM/BPMV out of the bracket high enough to allow clearance to remove the insulator mounting bolt and the EBTCM.



5. Remove the insulator mounting bolt from the EBTCM.
6. Remove the four EBTCM to BPMV bolts.
7. Separate the EBTCM from the BPMV by gently pulling apart until separated. Be careful not to damage seal.

1. Clean the BPMV gasket surface with alcohol using a clean rag.
2. Install the EBTCM to the BPMV.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: If the insulator nut was removed it must be replaced with a new insulator nut (3).

Tighten
Tighten the four mounting bolts to 3 N·m (27 lb in), then tighten to 6 N·m (53 lb in).

3. Install the front EBTCM insulator mounting bolt.

Tighten
Tighten the EBTCM insulator mounting bolt to 14 N·m (10 lb ft).




4. Install the EBTCM/BPMV into the bracket.
5. Install the three insulator nuts (2) (3).

Tighten
Tighten the three insulator nuts to 10 N·m (89 lb in).

6. Connect the EBTCM harness connector.

Important: Both sides of the EBTCM harness connector must be engaged with lever before closing.

7. Turn the ignition switch to the ON position, engine off.
8. Perform the Diagnostic System Check - ABS .