GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Engine 🢒 Engine Mechanical - 5.7L 🢒 Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure

    Object Number: 99640 Size: SH
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Remove the Engine Oil Pressure (EOP) sensor electrical connector.

    3. Object Number: 99641 Size: SH

    Important: Clean the area around the EOP sensor before removal. This avoids debris from entering the engine.

  3. Remove the EOP sensor.

Installation Procedure

    Object Number: 99641 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the new EOP sensor.

    2. Tighten
    Tighten the EOP sensor to 20 N·m (15 lb ft).


    Object Number: 99640 Size: SH
  2. Install the EOP sensor electrical connector.
  3. Install the intake manifold. Refer to Intake Manifold Replacement .