- Install a NEW oil pan cover gasket, the transfer cover and the bolts.
- Install the oil temperature sensor.
- Install a new oil filter bypass valve (2) into the oil pan, if required.
- Install the oil filter fitting (1).
- Install the oil filter.
- Install the oil pan drain plug.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil pan cover bolts to 12 N·m (106 lb in).
Tighten
Tighten the oil temperature sensor to 20 N·m (15 lb ft).
Tighten
Tighten the oil filter to 55 N·m (40 lb ft).
Tighten
Tighten the oil filter to 30 N·m (22 lb ft).
Tighten
Tighten the oil pan drain plug to 25 N·m (18 lb ft).
