GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: Do not over-flex or damage the flex joint when moving the flex joint from the normal mounting position.

Important: A service exhaust muffler will be needed when replacing the exhaust extension pipe on an originally equipped, welded system.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the exhaust muffler.

  3. Object Number: 1546675  Size: SH
  4. Cut the exhaust extension pipe just forward of the weld at the front of the exhaust muffler.
  5. Release the muffler from the underbody hanger insulators and remove the exhaust muffler.

  6. Object Number: 1388612  Size: SH
  7. Support the catalytic converter pipe.
  8. Remove the catalytic converter pipe-to-exhaust extension pipe nuts.
  9. Release the exhaust extension pipe from the underbody hanger insulators, and support the extension pipe.
  10. Separate the extension pipe from the converter pipe and remove the extension pipe from the vehicle.
  11. Clean the converter pipe flange surface of any remaining gasket material.

Installation Procedure


    Object Number: 1388612  Size: SH
  1. Install a NEW exhaust gasket to the service exhaust extension pipe. The gasket is designed to be retained to the flange by the flange studs.
  2. Connect the extension pipe to the converter pipe, and support the extension pipe.

    Notice: Refer to Fastener Notice in the Preface section.

  3. Install the catalytic converter pipe-to-exhaust extension pipe nuts.
  4. Tighten
    Tighten the nuts to 30 N·m (22 lb ft).


    Object Number: 1546675  Size: SH
  5. Install the exhaust extension pipe to the underbody hangers insulators.
  6. Install the muffler to the vehicle.
  7. Slide the muffler inlet pipe over the extension pipe, then install the muffler insulator to the underbody hanger.
  8. Install a muffler clamp to the muffler inlet pipe. Position the clamp approximately 19 mm (¾ in) from the edge of the muffler inlet, with the clamp nuts oriented away from the evaporative emission (EVAP) canister.
  9. Align the muffler and tailpipe to the vehicle underbody and rear bumper fascia.
  10. While maintaining muffler positioning, tighten the exhaust clamp nuts.
  11. Tighten
    Tighten the nuts to 45 N·m (33 lb ft).

  12. Lower the vehicle.