Removal Procedure
- Remove the front bucket seat. Refer to Seat Replacement .
- Position the seat back to the most forward position.
- Unfasten the J-hook retainer (2) at the bottom of the seat back cover (1).
- Remove the recliner cable from retaining tab the seat cushion frame.
- Remove enough of the cover in order to gain access to the seat back recliner bolts.
- Remove the seat back recliner bolts.
- Lift upward on the seat back assembly.
This will separate the seat back assembly from the recliners.
Installation Procedure
- Align the seat back assembly to the recliners.
- Install the seat back recliner bolts.
- Reposition the seat back cover to a desired appearance.
- Route the recliner cable onto the cushion frame.
- Fasten the J-hook retainer (2) at the bottom of the seat back cover (1).
- Install the bucket seat. Refer to Seat Replacement .
- Return the seat back to the original position.
Slide the assembly downward along the recliners until the fastener openings are aligned.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 18 N·m (13 lb ft).
