GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Classic 🢒 Body 🢒 Instrument Panel, Gages, and Console 🢒 Cupholder Replacement

Removal Procedure

    Object Number: 706203 Size: SH
  1. Fully extend the instrument panel cupholder.
  2. Remove the screws from the front of the I/P cup holder.
  3. Remove the driver side I/P outer trim cover.
  4. Remove the screw from the side of the I/P cupholder.
  5. Remove the I/P cupholder from the I/P carrier.

Installation Procedure

    Object Number: 706203 Size: SH
  1. Install the I/P cupholder to the I/P carrier.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the I/P cup holder screws to the I/P cup holder.

    3. Tighten
    Tighten the screws to 2.3 N·m (20 lb in).

  3. Install the screw to the side of the I/P cupholder.

    4. Tighten
    Tighten the screw to 2.3 N·m (20 lb in).

  4. Install the driver side I/P outer trim cover.